46
After the mounting hole has been routed and the 13-pin jack
plate has been curved to conform to the edge of the guitar
(see instructions in the Routing, Drilling, and Notching section
of this manual) bolt the 13-pin jack plate to the 13-pin jack
using the supplied nuts, bolts, and lock washers. Be careful to
align the Traktion switch with the slot in the 13-pin jack plate;
tightening the bolts with this slot misaligned will damage the
Traktion switch and may make the Hexpander unusable. When
tightening the bolts, make an eort to center the 13-pin jack
in the round hole in the 13-pin jack plate. Perfect centering is
not necessary, but severe misalignment will prevent the 13-
pin plug from seating properly and making a good connection.
13-pin jack
Align the 13-pin jack plate with the four screw holes drilled in the
guitar body. Make sure that the 13-pin jack is oriented the same way
as planned when making the mounting hole, as it is not symmetrical
and cannot be reversed 180 degrees. Attach the 13-pin jack plate
to the guitar body using the four small wood screws supplied.
To Next Page
Loading...
Need help?
General