28
Reversible installation
If you have a vintage instrument and its value may be aected
by modications, or if you want to try the ghost® system before
committing to the modications required, you can do a reversible
installation. A ghost® system installed this way may not be as
neat or as convenient, but you can return the instrument to its
original condition if you choose to remove the ghost® system.
Strats and Teles: Install the pickups without notching the pick
guard. The pick guard will remain slightly raised over the wires,
and the wires will not be evenly spaced. Or, you can order a
replacement pick guard*, set your original pick guard aside,
and drill and notch the replacement. Converting your tone
control by soldering the supplied wiring harness is reversible.
13-pin jack: mount it in a replacement pick guard or rear cover plate.
Acoustic Volume: You can omit the volume pot and connect the
yellow and purple wires together and operate the Acousti-Phonic
at full volume.
To Next Page
Loading...
Need help?
General