3
Saddles
Notching the pick guard or pickup ring ............29
Slotting the base plate *optional*......................30
Drilling between control cavities ........................31
Hexpander
13-pin jack.................................................................32
Enlarging the control cavity..................................39
Curving the Jack Plate............................................39
Acousti-Phonic
Stereo switched Jack (no routing required)......40
9v battery...................................................................40
Installing Ghost® Modular Components
Saddles............................................................................41
Pickup wires...............................................................41
Color code .................................................................42
Signal/ground color code .....................................43
Summing board ......................................................43
Extension harness *optional*..............................43
Seating and setup....................................................44
Hexpander.....................................................................45
13-pin jack.................................................................46
Connecting the 13-pin jack..............................47
Traktion switch.........................................................48
Connecting Pickups to the Hexpander.......49
To Next Page
Loading...