4-003 Gear box Hole Line Boring with the Ecopress Illustration 4-003-01/02
The following hole line borings can be drilled with the standard equipment
For spindle spacing, see Illustration 4-003-01
- Bore holes for cabinet hinges with Grass specified hole pattern
- Bore holes for visible cabinet hinges with Grass specified hole pattern
- Bore holes for dowel baseplates with dowel distance of 32 mm
- Bore holes for drawer front with a distance of 32 or 64 mm for the Grass-Zarge system 6000/7000
- Bore holes for drawer back panels for Grass Zarge system 6000/7000
(with pendulum stop as an accessory)
- Bore holes for fastening hardware with borehole distances of 32 / 64 mm
The following hole line borings can be drilled with the 5-spindle hole line boring gear box.
For spindle spacing, see Illustration 4-003-02
- Hole line boreholes in groups of 5 boreholes
- Drilling of fastening holes for pulls with hole distances of 32 / 64 / 96 or 128 mm
- Boreholes for wing base plate with hole distances of 32 mm
To Next Page
Loading...
