7-1 Requirements for Operators
This machine must only be operated by trained persons who are familiar with handling the machine. This knowledge
may be obtained by studying the operating instructions thoroughly or by hands-on training by a specialist.
The operators must be physically able to operate the machine. The machine owner must make sure that the operators
are utilizing the machine according to the operating instructions.
It is the machine owner’s responsibility to follow these instructions.
7-2 Setting-Up the Ecopress
7-201 Installing the Drill Bit Into the Drill Chuck on the Ecopress llustration 7-201-01
Tools needed: Allen wrench 3 mm
- Turn off the main switch on the electric motor.
- Loosen the fastening screw (1) with the Allen wrench 3 mm.
- Insert the drill bit until the stop, noting the position of the surface of the drill bit.
- Tighten the fastening screw.
Caution:
If the drill chucks do not have drill bits, screw (1) must be completely unscrewed and stored with the tools.
Drill chucks without drill bits, that have loose fastening screws, can cause damage to the gear box. This is not
covered under the guarantee.
7-202 Installing an Insertion Die Illustration 7-202-01/02
- Turn the insertion arm upward.
- Loosen the clamping screw of the insertion die.
- Mount the die, first with the clamping screw
- Tighten the clamping screws manually.
35
7. Operating the Ecopress
To Next Page
Loading...
