7-2 Setting Up the Ecopress
7-203 Installing the 5-Spindle Hole Line Boring Gearbox (accessory) Illustrations 7-203-01/02/03/04/05/06
Tools Needed: Allen wrench 3 mm
Allen wrench 5 mm
- Turn off the main switch.
- Take off the plastic cover of the gearbox.
- Remove all drill bits which are in the gearbox, including all of the fastening screws, according to chapter 7-201
- Mount the 5-spindle hole line boring gearbox, noting the position of the drill chucks and the position of the coupling
of the 5-spindle hole line boring gearbox.
- Tighten the Allen screw with the 5 mm Allen wrench.
- Attach the gearbox cover.
- Adjust the turn-on timing of the electric motor, according to point 7-304-01 with the Ecopress-Pneumatic.
- Adjust the turn-on timing of the electric motor, according to point 7-305-01 with the Ecopress-Manual.
37
7. Operating the Ecopress
To Next Page
Loading...
