2-006 Dangers and Safety Measures
Dangers Safety Measures
Tool releases chuck with clamping screw
Tool breaks use exclusively authorized products
(for example, from the Grass GmbH product line)
Contact with tool all tools are behind transparent covers
Tool - Contact with the machine safety - drilling depth stop
Tool - being thrown out tool stops
Feed mechanism the Ecopress-Manual does not have an
automatic feed motion. It has a manual feed.
Workpiece clamping device reduced pressure (reduced hold down force)
(unless available - accessory)
Risk of impact not applicable, because the stroke motion is slow
Drive the direct drive is completely enclosed
Tool sets forward feed for stroke motion
non self-locking buttons with collar
meet safety margins EN 294 depending on the risks
the Ecopress-Manual has only a manual feed
Control System electrical control with P-E-Wandler, non self-
unexpected tool start locking button with collar,
from feeding speed to motor first runs after being switched on.
operating speed
Control System non self-locking button with collar
unexpected lifting disengagement the Ecopress-Manual has only a manual feed
Control System switch cam
Press to begin tool start
Electricity Equipped according to EN 60204 part 1,
VDE 0100 in accordance with IEC 384
Noise measured emissions values correspond to the
current state of technology; work place
emissions values are under 85 dB (A)
Dust the wood dust emissions fall below limits
with the connected dust collection system
(available only as an accessory with the Ecopress-Manual)
To Next Page
Loading...
