7-3 Adjusting the Ecopress
7-301 Adjusting the Boring Depth Illustration 7-301-01
Tools needed: Allen wrench 3 mm
- Loosen the set screw (1) with the 3 mm Allen wrench
- Turn the operating control (2) clockwise ( the adjusting control moves downward over the thread ).
The boring depth is decreased about 1 mm for each rotation.
- Tighten the set screw.
7-302 Adjusting the Boring Distance Illustration 7-302-01
Tools needed: None
- Loosen both clamping levers (1).
- Slide the fence (2) to the desired dimension.
- Read scale (3).
- Tighten both clamping levers (1).
41
7. Operating the Ecopress
To Next Page
Loading...
