19
Adjustable Parameters
• NiCd, NiMH batteries
Parameter Short description
Current The default value, inherited from the “Proles” menu to 1C, can be adapt-
ed within the “Maximum capacity” of the charge port rate and the charger
features, see display 2 of the menu “Settings” on page 43, in the range of
0.1 to a maximum of 30 A.
Delta Peak Sensitivity adjustment of the delta Peak in mV per cell. Default: 5 mV /
cell NiMH (Setting range: 0 ... 15 mV) and NiCd 7 mV / cell (range: 5 ...
25 mV)
Trickle charge OFF, 50 to 500 mA in 50 mA steps, AUTO (default value: OFF)
Maximal tempera-
ture
Setting range: 10 ... 80 ° C (Default: 50 ° C). If the temperature sensor is
connected, the charge process is stopped automatically when that tem-
peratures is exceeded.
Maximal capacity Setting range: 10 ... 150% in 5% increments, OFF (default value:
120%). To avoid damage from overcharging, the charge stops when the
limit is exceeded.
Safety timer Setting range: 10 ... 900 minutes in 5 minute increments OFF (de-
fault value:
120 min). To avoid damage from overcharging, the charge stops when
the limit is exceeded.
• LiFe, LiIo and LiPo batteries
Parameter Short description
Voltage Maximum cell voltage at constant charge (CV)
Current The default value, inherited from the „Proles“ menu to 1C, can be ad-
apted within the „Maximum capacity“ of the charge port rate and the
charger features, see display 2 of the menu „Settings“ on page 43, in the
range of 0.1 to a maximum of 30 A.
Maximal tempera-
ture
Setting range: 10 ... 80 ° C (Default: 50 ° C). If the temperature sensor is
connected, the charge process is stopped automatically when that tem-
peratures is exceeded.
Maximal capacity Setting range: 10 ... 150% in 5% increments, OFF (default value:
120%). To avoid damage from overcharging, the charge stops when the
limit is exceeded.
Safety timer Setting range: 10 ... 900 minutes in 5 minute increments OFF (de-
fault value:
120 min). To avoid damage from overcharging, the charge stops when
the limit is exceeded.
To Next Page
Loading...
Need help?
General
