Do you want to stop
the operation?
ESC STOP
If it is touched the STOP button at the bottom of the display during the actual
discharge process, it appears the display on the left. Tapping “Yes“ will cancel
the further running in the background discharge. Tapping “No“, the window
hides again, and takes the discharge operation run unaffectedly.
PM 03:15:35
DISCHG
NORMAL
END : VOLTAGE
The operation is finished.
Pls touch this window
and then the window will
disappear.
Operation Finished
After proper completion of the discharge process the charger emits audible
signals and the display shows corresponding informations.
So tap the window and afterwards, if necessary, the STOP or ESC key to re-
verse to basic display.
Menu CYCLE
In the menu „PROFILE“ you have stored the data of your batteries and these can be added to
the menu „CHARGE“ and „DISCHARGE“ to the charge or discharge parameters. In this menu,
you can now create charge / discharge cycles based on these parameters, in which both types of
cycle, as well as the number of cycles and the pause between cycles within the speci ed limits are
customized.
The parameters offered by this mode depend on the battery type selected in the menu „PROFILE“.
The selected location is displayed in the upper display and, once this eld is highlighted in blue by
touching with a nger or the supplied stylus, it can be selected individually. Similarly proceed with
the other option elds as shown below.
Adjustable Parameters
Parameter Short description
Sequence
Charge Discharge, Discharge Charge
1x Discharge, then Charge Discharge
Number of cy-
cles
1 … 10
C D delay
interval between “Charge” and “Discharge”: 1...30 minutes
D C delay
interval between “Discharge” and “Charge”. 1...30 minutes
D Auto Acquired charge current from menu “CHARGE”. The
charge current can therefore be adjusted only in the menu
“CHARGE”.
PM 09:02:02
CH1
CH2
CYCLE
Direction
Cycle nr.
C D Delay
Charge-Discharge
00 NiCd Auto Mode
C D
1
10m
10m
D C Delay
D Auto
C Auto
Charge
Discharge
To Next Page
Loading...
