11,789Vc 0,067Vr
[01]
C-D
After the lapse of the aforementioned 5 seconds or if necessary, after a manu-
al start, cycle process is begun. Otherwise, an error message is shown.
Note:
Tap the image to go directly to the „data display“, see page 35
.
PM 09:02:59
CYCLE
CC/CV
CH1 CH2
13 LiPo 03s 2200
0.0°C
00:01:56
67mAh
11.678V 2.20A
11.97Vin 33.3mΩ
STOP
11,789Vc 0,067Vr
[01]
D-C
2
3
4
5
6
7
8
9
10
11
1
12
1 Cycle mode (C-D, D-C, D:C-D)
a ashing letter indicates the status
C = Charge, D = Discharge
2 Actual mode
3 Time occurred
4 Battery temperature (Only with sensor)
5 Actual charge / discharge capacity
6 Actual charge voltage
7 Actual charge current
8 Actual voltage of the power supply
9 Actual cycle
10 Actual battery internal resistance
11 Vc = Voltage center (the center line voltage value actually assigned)
Vr = Voltage range (vertical range of the voltage display)
12 History of the discharging voltage
PM 09:03:14
CYCLE
CC/CV
1.0A
3.0A
Ser Current
15.0A
5.0A
10.0A
20.0A
[01]
C-D
To change the actual charge or discharge current tap the display to the actual
discharge current (6). In the lower half of the display appears a selection win-
dow.
To Next Page
Loading...
