11
tor specific VHF marine channels, they should be programmed as CONV
objects. If you want to monitor your favorite amateur radio channel, it should
be stored as a CONV object. If your police or fire department uses a chan-
nel, or channels that are not trunked, but part of a “plain old radio system”,
they should be stored as CONV objects.
LMIT
LMIT is used to represent a Search Range, or Limit Search Object. LMIT
objects contain the parameters necessary for the radio to search a range of
individual frequencies between a lower and upper limit frequency.
SRVC
SRVC is used to represent a Service Search Object. SRVC objects are
further divided into Public Safety, Aircraft, Amateur, CB, Marine, and FRS/
GMRS/MURS/DOT. SRVC objects are similar to LMIT objects, but are prepro-
grammed to search all frequencies associated with the selected service. For
example, selecting the Amateur SRVC search will search selected amateur
radio frequency ranges in the VHF and UHF portions of the radio spectrum.
SWPR
SWPR is used to represent a Spectrum Sweeper Object. SWPR objects con-
tain the parameters necessary for the radio to rapidly sweep a range of radio
spectrum for strong signals from nearby transmitters.
The FCC Wants You To Know
This equipment has been tested and found to comply with the limits for a
scanning receiver, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
To Next Page
Loading...
