86
Latch LED On or Off
Normally the ALERT LED is active
only while the object is receiving a
transmission. When Latch is on, the
ALERT LED will remain lit after the
transmission is complete, unless
overridden by a subsequent object
that is also using the ALERT LED.
Backlight On, Off or Flash
Controls whether the backlight
should be on, off or flashing while
the object is active.
Alarm
None, Chirp, Hi-Lo,
Alert, Ring, 2-Chirp,
Fast Hi-Lo, DTMF#
Sets the Audible Alarm for the
TGRP object. When an Audible
Alarm is selected, the selected
alarm will play at the beginning of
each transmission on the TGRP ob-
ject, or anytime the scanner stops
for activity on the TGRP object
while scanning.
Fav Yes or No
When Yes, the TGRP object is a
member of the Favorites Scan List.
Skywarn Yes or No
When Yes, the CONV object is a
member of the Skywarn Scan List.
EXPERT BELOW
Delay On or Off
Controls whether a Delay is used to
wait for reply traffic after a transmis-
sion on the TGRP.
Delay Time 1-200 x 100 mS
Sets the amount of time (in 100
millisecond intervals) for the wait
for reply delay if Delay is On, e.g.,
20=2 seconds.
AudioBoost On or Off
Applies a 6 dB boost to audio levels
when the object is active
Hit Count Numeric value
Increments each time a transmis-
sion is received on the SWPR ob-
ject. Global “Hit Counts” must be
set to ON. Press the
Dflt
softkey
to reset to 0.
TSYS Menu Reference
The TSYS menu is used when creating new Trunking System objects, or ed-
iting existing Trunking System objects. All menus are shown in the scanner's
display as a three line window that can be scrolled up or down to access the
various different parameters. The active parameter is always the middle pa-
To Next Page
Loading...
