76
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 2. The scanner displays
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will reboot with file
system and global parameters reset to factory defaults.
Initializing the Scanner to Factory Defaults
If initializing the global parameters to factory defaults does not resolve your
problem, you may wish to initialize the entire scanner to factory defaults.
This operation will result in the clearing of your programmed data and the
loss of any custom changes you have made to the radio's global param-
eters. Use this option as a last result.
NOTE: This procedure clears all information you stored in the scanner's
working memory, AND resets the global parameters to factory defaults. Ini-
tialize the scanner only when you are sure the scanner is not working prop-
erly.
1. Turn off the scanner, then turn it on again. The scanner briefly displays the
Welcome/Owner screen.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The
scanner displays
To Next Page
Loading...
