88
Dwell 0-200 x 100 mS
Sets the amount of time the scan-
ner dwells on a Motorola, or EDACS
system control channel for activity
on programmed talkgroups. Use
0 for automatic mode, which uses
control channel information to de-
termine when all current talkgroup
information has been broadcast by
the system.
Multi-Site
Of f, R o am o r S ta t
(Stationary)
Used with networked Motorola
trunked radio systems. When Multi-
Site=Off, the scanner will find
the first usable control channel in
the control channel list and use it
to track the system. When Multi-
Site=ROAM, the scanner will al-
ways attempt to lock on to control
channels where the decoding qual-
ity is greater than Threshold Hi, and
will search for new control channels
when the decoding quality of a con-
trol channel drops below Threshold
Lo, and, if no control channels are
available that meet the Threshold
Hi criteria, the scanner will seek the
best control channel to use, and
continue checking periodically for a
new control channel that meets the
Threshold Hi criteria. When Multi-
Site=STAT, the scanner will track
the system using every usable con-
trol channel in the control channel
list.
Threshold Hi 1-99
Available when Multi-Site is set to
ROAM. Sets the control channel
decode % threshold for a site to be
considered good when looking for
a new site.
Threshold Lo 1-99
Available when Multi-Site is set to
ROAM. Sets the control channel
decode % threshold for a site to be
considered out of range, which will
begin the process of looking for a
new site.
Check All CC Yes or No
Available when Multi-Site is set to
Stat.
To Next Page
Loading...
