Gree A Series - Page 119

114
1. Remove
the front
panels.
(1)Remove screws at the
front panel;
(2)Loosened screws
should be put together
to avoid loss;
(3)Pull the front panel
upwards and then
remove it;
(4)Properly keep the
removed front panel to
avoid from being
damaged.
Note: there are two clasps
at each panel for
connecting with side
panels.
2. Remove
power lines
and the
electric
heater.
(1)Remove the insulation
of the compressor;
(2)Loosen screws of
power lines with a
screwdriver;
(3)Draw out power lines;
(4)Draw out the electric
heater.
Note: power lines and their
terminals should be
numbered to avoid
incorrect rewiring.
3. Disconnect
power lines to
the
compressor.
(1)Desolder pipes quick
to avoid deformation;
(2)Keep the replaced
compressor complete
for further analysis.
A Series Modular-type Air-cooled (Heat Pump) Chiller