Gree A Series - Page 120

115
4. Loosen
screws at feet
of the
compressor.
(1)Loosen screws at feet
of the compressor with
a adjustable or box
spanner.
(2)Loosened screws
should be put together
to avoid loss.
5. Replace
the
compressor
with a new
one.
(1)During replacement,
care must be taken to
not damage rubber
pads;
(2)Seal the replaced
compressor to prevent
moisture entering;
(3)Place a new
compressor at the
rubber pads. Steel
bushing is required for
rubber pads;
(4)Tighten the steel
bushing with screws.
A Series Modular-type Air-cooled (Heat Pump) Chiller