26
(4)At the desired function setting page, touching“OK” will save the setting and
touching“Cancel” will exit this setting. Meanwhile the control panel will back to the function
setting page under both conditions.
[Notes]
1)When there is submenu for the desired function option, by touching it, the control panel
will access to the sub-menu setting page.
2)At the setting page, press “OK” finish and save this setting. However, in this case, there
will be no alert message.
3)At the function setting page, when any function status is changed and memorized, it will
resume the changed status upon next power-on.
See the table below for more details about each function.
No Parameter Name
Range Interpretation
1 Mode
Manual-defrost; Heat;
Cool
It can be set under the OFF
status.
2
Electric heating
Off; On
It is unavailable for the cooling
only unit.
3
Auto anti-freezing
Off; On
/
4 Contact-control ON/OFF
Disabled; Enabled
/
5
Timer ON/OFF
Disabled; Enabled
It allows the unit to be timed
on or off.
6
Timer setting
Enter It is used to set the timer.
7
Manual defrosting
Enter
It can be set when the unit is
off and “Mode” is set to
“Manual-defrost”.
8
ON/OFF memory
Off; On
/
9
Energy-saving mode
Off; On
/
10
Quiet mode
Off; On
/
11
Remote monitoring address
1~255 /
12
Resetting
Enter
Except the language setting
13
Field commissioning
Enter /
14
Factory commissioning
Enter /
(1)Mode
Operation Instructions
At the function setting page, when the unit is OFF, by touching “Mode”, the control panel
will go to the corresponding setting page. Then, select the desired option. After that, by
A Series Modular-type Air-cooled (Heat Pump) Chiller
To Next Page
Loading...
