Model T33903/T33904 (Mfd. Since 07/23)
-23-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling key disables the switch
properly.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
Motor should run smoothly and without
unusual problems or noises.
4.
Remove switch disabling key, as shown in
Figure 25.
5.
Try to start machine with ON/OFF switch.
Machine should not start.
— If machine does not start, switch dis-
abling feature is working correctly.
Congratulations! Test Run is complete.
Complete Spindle Break-In before pro-
ceeding with operations.
— If machine does start, immediately stop
machine. Switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with reg-
ular operations. Call Tech Support for
help.
Figure 25. Removing switch key from ON/OFF
switch.
To Next Page
Loading...
Need help?
General
