English Environmental compliance
Plate Heat Exchanger
EN
EN
Environmental compliance
AlfaLaval endeavours to perform its own op-
erations as cleanly and efficiently as possi-
ble, and to take environmental aspects into
considerattion when developing, designing,
manufacturing, servicing and marketing its
products.
Unpacking
Packing material consists of wood, plastics, card-
board boxes and in some cases metal straps.
• Wood and cardboard boxes can be reused,
recycled or used for energy recovery.
• Plastics should be recycled or burnt at a
licensed waste incineration plant.
• Metal straps should be sent for material recy-
cling.
Maintenance
• During maintenance oil and wear parts in the
machine are replaced.
• All metal parts should be sent for material recy-
cling.
• Worn out or defective electronic parts should be
sent to a licensed handler for material recycling.
• Oil and all non metal wear parts must be taken
care of in agreement with local regulations.
Scrapping
At end of use, the equipment shall be recycleed ac-
cording to relevant, local regulations. Beside the
equipmnet itself, any hazardous residues from the
process liquid must be considered and dealt with in
a proper manner. When i doubt, or in absence of lo-
cal regulations, please contact the local AlfaLaval
sales company.
To Next Page
Loading...
