3
APCD-500, rev10
APCD-500
TABLE OF CONTENTS
1. INTRODUCTION .....................................................................5
1.1. Precautions ........................................................................... 5
1.2. Symbols of the Manual ........................................................... 5
2. USER INTERFACE ..................................................................6
2.1. Location of the Controls ......................................................... 6
2.2. Adjusting a Parameter ............................................................ 7
3. MOUNTING INSTRUCTIONS .................................................... 7
3.1. Mounting the Controller on the Wall ......................................... 7
3.2. Connections .......................................................................... 7
4. CONTROLLER OVERVIEW .......................................................8
4.1. Features ............................................................................... 8
4.2. Chain Disk System Setups ...................................................... 8
4.2.1. Cascade Setup .................................................................8
4.2.2. Independent Chain Disk Systems with a Common Auger .......9
4.2.3. Independent Chain Disk Systems with Individual Augers ........9
4.3. Feed Distribution Modes ......................................................... 10
4.3.1. Timed Feed Distribution .....................................................10
4.3.2. Continuous Feed Distribution .............................................. 10
4.4. Filling Process ....................................................................... 11
4.4.1. Filling Cascaded Chain Disk Systems with Continuous Feed
Distribution Mode .............................................................13
4.4.2. Filling Cascaded Chain Disk Systems with Timer Mode ..........15
4.4.3. Filling Independent Chain Disk Systems with a Common Bin
Auger using Continuous Feed Distribution Mode ...................18
4.4.4. Filling Independent Chain Disk Systems with a Common Bin
Auger using Timer Mode .................................................... 20
4.4.5. Filling Independent Chain Disk Systems with Individual Bin Au-
gers Using Continuous Feed Distribution Mode .....................23
4.4.6. Filling Independent Chain Disk Systems with Individual Bin Au-
gers Using the Timed Feed Distribution Mode .......................25
4.5. Feed Delivery Process ............................................................. 28
4.6. Feed Cycle ............................................................................ 28
5. PARAMETER SETTINGS .........................................................29
5.1. Controller Status .................................................................... 29
5.2. Run Time History ................................................................... 29
5.3. Time & Date .......................................................................... 30
5.3.1. Adjusting Improper System Time ........................................30
5.4. Feed Cycle Settings ............................................................... 30
To Next Page
Loading...
Need help?
General