GSi Chain Disk APCD-500 - Index

45
APCD-500, rev10
APCD-500
A
Actuator / Air valve
Activation & settings 34
Actuator status LED 6
Current actuator status 29
Dump
Manual feed dump 38–39
Principle of operation 28
Settings 30
Principle of operation 28
Security switch 34
Adjusting a parameter 7
Air valve see Actuator/Air Valve
Alarms
Alarm conditions 40
Status LED 6
Amperage draw see Chain Disk
Auger see Bin auger
B
Backup 42
Bin auger
Auger status LED 6
Principle of operation 11
Settings 33, 35
Buttons 6
C
Card (Core) 44
Card (Memory) 42
Chain Disk System
Amperage draw
Current status 29
Overload protection 11
Overload protection settings 34
Test mode 39
Chain disk status LED 6
Filling Process see Feeder setup
Manual lling 37
Run time
History 29
Max run time 35
Run time settings 32
Safety switch
Status LED 6
Setup
Cascade setup
Activation 32
Feeders’ lling process 11, 13–15, 15, 37
Setup view 8
Independent feeders with 1 auger
Activation 32
Feeders’ lling process 11, 18–20, 37
Setup view 9
Independent feeders with ind. augers
Activation 32
Feeders’ lling process 11, 23–25, 37
Setup view 9
Communication speed 42
Connections 7
Contrast 42
Controller
Backup 42
Controller’s description 8
Current status 29
Location of the controls 6
Mounting instructions 7
Status LEDs 6
Update 42
Version 36
Core card (replacement) 44
Current consumption see Chain Disk
D
Date 30
Display 6
Drive units see Chain Disk
Dumps see Actuator/ Air valve
E
Electrical specications 41
F
Feed cycles
Activation 35
Feed cycle status 29
Principle of operation 28
Programming feed cycles 30
Warning 30, 37
INDEX