36
APCD-500, rev10
APCD-500
Feed Purge Time Delay — The “Feed Purge
Delay” is the amount of time required for feed
lines to get empty when a common auger is
used. Note that the “Purge Delay” must be
higher than “A u ge r D e l a y”. Set this param-
eter to the desired value. * This parameter is
available if many Chain Disk Systems are sharing
a common bin auger.
Feed Purge Time
Delay 1:00m:s
Use Password — Select “Yes” to enable a
password; this password is used to restrain
the access to the Installation and Feed Cycle
menus.
Use password?
Yes
Change password? — Select “Yes” if you
wish to modify the controller’s password then
press the down-arrow key. *This parameter is
available if the password option is enabled above.
Change password?
Yes
1. Press MODIFY. The first two digits of
the password flash on the display.
EnterNewPassword
** ** **
2. The new password must be entered,
one number at a time. Use the arrow keys
to enter the first number. Press MODIFY
to step to the next number. Use the arrow
keys to enter the second number, etc.
Version — This is the current version of your
controller.
APCD-500
Version X.X
To Next Page
Loading...