1. MemoryCard -> Control
Choose 1. MemoryCard -> Control and press
MODIFY to load a new configuration file into
your controller. This transfer will update your
controller’s software and parameter settings.
1
2
3
4
5
Select file & press
FILE~1.D MP
FIL E~2.DM P
FIL E ~3.D MP
When selecting this option, a list of all config-
uration files located on the card is displayed
(*.DMP files). Select the desired file and then
press the ADJUSTMENT up- and down-arrow
keys for 5 seconds to start the transfer.
Note that the controller can only read
the files that are located at the root
of the USB drive. It cannot access
any sub-directory!
2. Control -> MemoryCard
Choose 2. Control -> MemoryCard and press
MODIFY to save your controller settings on
the USB drive. The saving process will start
as soon as you enter this menu.
1
2
3
4
5
Select file & press
FILE~1.D MP
FIL E~2.DM P
FIL E ~3.D MP
The controller will create a new CONTROL-
LER~1.DMP file at the root of the USB drive.
If this file name already exists, it will be saved
under a different name (“CONTROLLER~2.
DMP” for instance). This way, the controller
will never erase a file on the card.
3. Update Firmware
Choose 3. Update Firmware and press MODI-
FY to download a new firmware file into your
controller. This process will not affect your
parameter settings.
1
2
3
4
5
Select file & press
FILE~1.P K G
FIL E~2.PKG
FIL E ~3.P K G
When selecting this option, a list of all
firmware files located on the USB drive is
displayed (*.PKG files). Select the desired file
and then press ADJUSTMENT up- and down-
arrow keys for 5 seconds to start the transfer.
Note that the controller can only read
the files that are located at the root
of the USB drive. It cannot access
any sub-directory!
4. Save Event Buffer
Choose 4. Save Event Buffer and press MOD-
IFY to save the event buffer of the controller
on your USB card (event.txt).
Simultaneously press and hold
the MENU SELECT up- and down-
arrow keys for 5 seconds to exit
from the transfer menu.
Remove the USB drive from the
connector when the transfer
is over!
43
APCD-500, rev10
APCD-500
To Next Page
Loading...