GSM Commander GC0321 - Page 10

58 pages

To Next Page

To Previous Page

Screen 4:

Installation is in progress.

Screen 5:

Installation has been completed

successfully. Click

Screen 6:

Click

Main Page

Table of Contents2
Features4
Specifications5
System Requirements5
Dimensions6
Installation7
- Environment7
- Power Supply7
- USB Port7
- SIM Card7
- Antenna8
- Software Installation8
- Mounting11
- Optically - Isolated Digital Inputs11
- Outputs13
- Temperature Sensor14
- Analog Input15
- Battery Input16
- Internal Battery16
- Expansion Unit17
- Dimensions of Expansion Unit18
- Status Leds19
- Testing the GSM Commander21
- Commissioning Mode22
Configuration VIA PC23
- Basics23
- Software Tabs24
- Numbers Tab List a and B24
- Messages Tab24
- Behaviour Statements Tab24
- Settings Tab25
- Status Tab25
- IO Names Tab26
- Analog Scaling Tab26
- Lock Setup26
Configuration Via SMS27
- Set Administrator Number27
- Clear Administrator Number27
- Check Administrator Number28
- Check Airtime28
- Add a Number to the List28
- Remove a Number from the List28
- Enable/Disable Statements28
- Override GPRS Settings29
- Reset GPRS29
- IMEI Number30
- Switch SIM Card30
- Reset GSM Commander30
IF-THEN Behaviour Statements31
- Supported if Conditions31
- Supported then Actions37
Multiple Actions to a Single if Condition39
Message Parameters40
Variables41
Timed Operations41
Prepaid Airtime Voucher Loading42
Serial Port42
- RS232 Configuration43
- Serial Functionality43
Firmware Updates47
Low Power / Battery Operation48
4-20Ma Analog Application Note49
Special Settings50
- NITZ Timekeeping50
- Set Variable Via SMS50
- Jamming Detection50
Application Examples51
- Example 1: Periodic Message51
- Example 2: Monitor Alarm51
- Example 3: Control an Appliance52
- Example 4: Gate / Garage Door Opener52
- Example 6: Set an Output as a Flag52
- Example 5: Contact to Contact Relay53
Troubleshooting54
- GSM Commander Setup Software Reports54
- GSM Commander Setup Software Reports "Hardware Not Detected54
- GSM Commander Does Not Send any SMS Messages / Error Codes55
- GSM Commander Does Not Display the Airtime Value56
- GSM Commander Does Not Respond to Voice Calls56
Guarantee57
Disclaimer / Important Notice57
Important Notice57
Manufacturer Contact Details58

GSM Commander GC0321 - Page 10

Table of Contents