7.3. Check Administrator number
This command can be sent from ANY number, and is useful to determine which number is the correct
administrator number.
ADMIN?
The GSM Commander will reply with the administrator number in the reply message.
7.4. Check Airtime
This command can be sent from ANY number, and is useful to check the amount of airtime remaining
on the unit. To check airtime, you must send:
ATCHECK
The GSM Commander will reply with a message detailing the current airtime.
7.5. Add a Number to the list
This command can only be sent from the administrator number. To add a number to the list, the
administrator must send:
ADMIN ADDN 0831234567
The GSM Commander will reply with a confirmation message.
7.6. Remove a Number from the list
This command can only be sent from the administrator number. To remove a number
(+27831234567) from the list, the administrator must send:
ADMIN REMN 0831234567
The GSM Commander will reply with a confirmation message.
Please Note: The value predefined by the user via the software under the “Numbers Tab” (as
illustrated below), will determine how many numbers are able to be added and removed by means
of SMS.
7.7. Enable/Disable statements
This command can only be sent from the administrator number. To enable or disable a specific
statement in the setup on the GSM Commander, the administrator must send:
ADMIN STATEMENT 8 ON or ADMIN STATEMENT 8 OFF
This will either enable(ON) or disable(OFF) statement 8 respectively. The GSM Commander will reply
with a confirmation message.
© Polygon Technologies. All rights reserved Page 28
To Next Page
Loading...
Need help?
General