GSM Commander GC0321 - 6. Configuration Via PC; 6.1. Basics

To Next Page

To Previous Page

6. CONFIGURATION VIA PC

6.1. Basics

The following is required to configure the GSM Commander:

➢ A PC running Windows XP / Vista / Windows 7 / Windows 8/ Windows 10

➢ Setup utility installed on the PC (Available on the CD supplied with the product)

or downloaded at https://gsmcommander.com/downloads/software

➢ USB cable

➢ Power supply (See sec 6.2)

➢ Antenna (See sec 6.5)

➢ SIM card(s) (See sec 6.4)

Please note: The GSM Commander will eventually startup if no SIM card is inserted, but there

would be no GSM functionality, which means none of the GSM features will work.

Follow these steps:

Step 1:

Insert SIM card(s) into unit (when unit is not powered up)

Step 2:

Connect GSM Commander to PC via the supplied USB cable

Step 3:

Connect power to the GSM Commander

Step 4:

Run the Utility

Start Menu> All Programs [All Apps] >GSM Commander V7 > Configure GSM Commander)

The software will show this screen when

started. Here you can select whether you

would prefer opening an existing setup

from a file on your PC, retrieve the setup

currently on the GSM Commander, just

open to the main screen.