7. CONFIGURATION VIA SMS
The GSM commander provides functionality to provide some configuration changes to be done via
SMS message (from the administrator number only). Note that the unit cannot be setup by SMS only.
A PC is still required to perform the initial setup. Thereafter, some simple changes to the setup may
be done using SMS messages.
Please note: The Configuration SMS is NOT case sensitive.
The following operations can be performed via SMS message:
➢ Set Administrator number
➢ Clear Administrator number
➢ Check Administrator number
➢ Check Airtime
➢ Add a number to the list
➢ Remove a number from the list
➢ Enable/Disable statements
➢ Configure GPRS settings
➢ Reset GPRS
➢ Set GPRS logging interval
➢ Switch SIM card
➢ Reset GSM Commander
7.1. Set Administrator number
This command can ONLY be sent from the administrator number(if one exists), otherwise it can be
sent from any number .
ADMIN SETADM 0831234567
This will store “0831234567” as the new administrator number. The GSM Commander will reply with
a confirmation message.
7.2. Clear Administrator number
This command can ONLY be sent from the administrator number.
ADMIN CLRADM
This will remove the current administrator number. The GSM Commander will reply with a
confirmation message.
© Polygon Technologies. All rights reserved Page 27
To Next Page
Loading...