8.1.14. IF time elapsed > X
A statement containing this IF condition, will trigger every X seconds or minutes.
8.1.15. IF Statement X has not triggered in a certain period
A statement containing this IF condition, will trigger if the referred-to-statement has triggered in a
specified period. Thus this type of statement actually monitors the triggering behaviour of another
statement.
8.1.16. IF Date/Time = X
A statement containing this IF condition, will trigger on a specific time every day within a specified range
of dates, or on every selected day of the week.
The user can choose between the following four options:
1. Everyday 2. Day-of-Week 3. Once per month 4. Specific Date Range
8.1.17. IF Power-up or Reset
A statement containing this IF condition, will trigger as soon as the unit has finished booting up.
8.1.18. IF GSM Signal Strength
A statement containing this IF condition, will trigger as soon as GSM signal strength meets the specified
requirements.
The user can choose between the following two options:
• Above X
• Below X
Thus, if the user chooses “Below X”, then as soon as the GSM signal strength goes below the specified
threshold, the statement will trigger. The same applies to the remaining options, provided their conditions
are met. The same applies to the other option, provided it's condition is met.
The user is able to specify a “Lockout Time” for this statement, which is the time that, after the
statement has triggered, it will not allowed to trigger again until this time has elapsed.
If the user selects a “Lockout Time” of zero and the “Below X” option, the statement will only trigger
once (will trigger again when the signal goes above and below “X”).
8.1.19. IF Statement X Triggers
A statement containing this IF condition, will trigger if the referred-to-statement has triggered. Thus this
type of statement actually monitors the triggering behaviour of another statement.
8.1.20. IF RFID Tag is read via Serial
A statement containing this IF condition, will trigger if a RFID tag is scanned via a Stealth RFID Reader
125KHz antenna (Product Code: GA100) that is fitted to the GSM Commander.
The user can choose between the same six options as listed under “IF Voice Call is Received”
(See sec 8.1.2 for more detail)
Please note: * Only available on the 0641 and 1281 models
** Only available on the 1281 model
© Polygon Technologies. All rights reserved Page 36
To Next Page
Loading...
Need help?
General