9
Figure 5 Security bezel
Table 4 Security bezel effect light
Standby Steady white: The system is in standby state.
Startup
• Beads turn on white from middle in turn—POST progress.
• Beads turn on white from middle three times—POST has
finished.
Running
• Breathing white (gradient at 0.2 Hz)—Normal state, indicating
the system load by the percentage of beads turning on from the
middle to the two sides of the security bezel.
No load—Less than 10%.
Light load—10% to 50%.
Middle load—50% to 80%.
Heavy load—More than 80%.
• Breathing white (gradient at 1 Hz )—A pre-alarm is present.
• Flashing amber (1 Hz)—A major alarm is present.
• Flashing red (1 Hz)—A critical alarm is present.
UID
• All beads flash white (1 Hz)—The firmware is being upgraded or
the system is being managed from HDM. Do not power off the
server.
• Some beads flash white (1 Hz)—HDM is restarting.
Ports
Table 5 Ports on the front panel
VGA connector DB-15 Connects a display terminal, such as a monitor or KVM device.
USB connector USB 3.0/2.0
Connects the following devices:
• USB flash drive.
• USB keyboard or mouse.
• USB optical drive for operating system installation.
Dedicated
management
connector
Type-C
Connects a Type-C to USB adapter cable, which connects to a
USB Wi-Fi adapter.
NOTE:
The server supports only Xiaomi USB Wi-Fi adapters.
To Next Page
Loading...
