HDE 04.10.2021 732.22.024
48
CC 200 Powerbank • Connection cable for a Powerbank for the emergency
power supply of the FT 200 in the event of a power failure
(emergency opening)
When using a Powerbank:
• Disconnect the FT 200 from the mains. Parallel operation
is not permitted!
• Connect and use Powerbank only in case of emergency
mode (power failure).
• Disconnect Powerbank from the Dialock system after
emergency mode.
• Only use the CC 200 Powerbank connection cable.
Please note separate installation instructions for this
purpose.
Powerbank Recommendation:
• The JPB20AHB and JPB30AHB models from Jauch are
tested and approved for use. Detailed information about
these products can be found at:
- Jauch Quartz GmbH
In der Lache 24
78056 Villingen-Schwenningen
Germany
+49 77 20 / 9 45-323
info@jauch.com
www.jauch.com
• Deviating products must comply with the specifications of
these models:
- Output: 12 V DC
- Capacity: min. 20100 mAh
- Connector: JPB20AHB (J210/5.5 x 2.1 mm)
JPB30AHB (adapter 5.5 x 2.1 mm / scope of delivery)
• Observe the operating instructions and all enclosed
information from the Powerbank manufacturer!
• Before connecting to the Dialock system, check the
charging status and the setting of the output voltage
(12 V DC).
• No permanent or parallel operation is permitted with the
Powerbank.
• Häfele does not accept any liability for damage caused by
non-approved Powerbanks.
Macros • Macros are programs which extend the functional scope
of the FT 200 / FT 200 CAP.
• Customer specific requirements (e.g. installation of an
acoustic signal generator or activation of an alarm
system) can be implemented with macro programmes
on request.
• The transfer to the FT 200 / FT 200 CAP takes place
via the MDU 110.
• If you have any questions concerning the development
or functionality of the macros, please contact your
responsible DIALOCK technician or www.hafele.com.
Extension Description
ins-src-732.22.024.book Seite 48 Mittwoch, 13. Oktober 2021 1:58 13
To Next Page
Loading...