EasyManua.ls Logo

hager XEV1K11T2 - Technical Characteristics

hager XEV1K11T2
116 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
Environmental conditions
Usage temperature -25°C to +50°C
Storage temperature -35°C to +70°C
Relative humidity 5% to 95%
Protection IP 55 – IK 10
Maximum altitude of operation 2000 m
Degree of pollution 3
Use intended for use by ordinary people
Electrical characteristics
Voltage 230 V~ / 400 V~ (three-phase version) -15% / +10%
Usage frequency 50/60 Hz +/- 1%
Nominal insulation voltage Ui 250 V~ / 500 V~
Charging station electrical protection
40 A circuit breaker, C curve, energy limitation class I²t 3, on a circuit
that cannot supply more than 6 kA in short-circuit (or equivalent)
Electrical protection of the charging station if Charging mode 2
supplied
16 A circuit breaker, C curve, energy limitation class I²t 3, on a circuit
that cannot supply more than 6 kA in short-circuit (or equivalent).
Maximum charging current/power Mode 3 T2/T2S socket (depending
on version)
32 A - 7 kW (single-phase version) / 32 A - 22 kW (three-phase version)
16 A - 4 kW (single-phase version) / 16 A - 11 kW (three-phase version)
Maximum charging current/power Mode 2 TE socket (depending on
version)
16 A - 4 kW
Electrical protection rating Class 1 (earth connection)
Overvoltage category 3
Earth connection diagram TN-S, TN-C-S, TT
Minimum/possible wiring
10 mm² in single or multi strand/16 mm² in multi strand.
Only the use of a copper conductor is authorised.
Mechanical characteristics
Weight 6.2 kg
Maximum weight supported by the cable support axed to the
charging station
7 kg
Height 549 mm
Width 250.5 mm
Depth 173 mm
Classification
Power input
Electric Vehicle (EV) power system connected to the AC power supply
network (permanently connected)
Power output alternate current power system for EV
Environmental and usage conditions indoor and outdoor use
Location of equipment for restricted access areas and unrestricted access areas
Type of mounting
surface mounting on wall mounting, on stand, fixed post, column and pipe.
Installation in a horizontal position on the ceiling or on the floor is prohibited
Category equipment 1
Charging mode
mode 3 via T2/T2S socket and mode 2 via TE socket depending on
version
Adaptor
no plug adapter can be used between the charging station and the
charging cable or between the charging cable and the car
Cable extension
the charging cable cannot be extended. The charging cable must be
in one piece and a maximum length of 7 m
• Charging station
19. Technical characteristics
• Identification of vehicle compatibility

Table of Contents

Related product manuals