– 29 –
5. Locate the door balance cable and insert an
Allen wrench or tool formed into a hook (as
shown below).
6. Lift the cable up and slide forward.
7. Slide the cable down and away from the
dishwasher. Do not release tension from the
cable.
(Continued next page)
8. Slide the cable into the cable clip to prevent
the spring from disconnecting from the cable.
CAUTION: If the cable is released, the spring and
cable may become disconnected. Depending
on the model and installation, reconnecting may
require the dishwasher to be removed from
installation.
The cable seated correctly into the clip is shown
below.
9. Repeat steps 5 through 8 on the opposite
side.
To Next Page
Loading...
Need help?
General
