Vehicle-mounted terminal fault indicator light:
the light “！” turns on when there are any faults
in the vehicle-mounted terminal
communication antenna, positioning antenna
and CAN bus, the signal is not normal, or the
vehicle is in a dismantled state. When the light
is on, it is necessary to check the
vehicle-mounted terminal and notify the
service provider.
OPS indicator light: When the light turns on, it
indicates that the driver is not on the driver's
seat or is not sitting properly. The light turns off
when the driver is seated and buckled up.
Parking indicator light
When the light turns on, it indicates that the
parking brake is applied. In order to drive the
forklift, the parking brake lever (e.g. hand
brake lever) should be released; when the lever
is released, the light turns off.
Warning
Driving the truck when the light is on
may cause damage to the engine, drive
system and other components.
Major fault indicator light [for forklift trucks
with an electronically controlled engine]
Air filter alarm indicator light
When the light turns on, it indicates that the
filter of the air intake system is blocked and the
truck must be stopped to clean the filter.
Seat safety belt alarm indicator light (optional
configuration)
When the start key is in the “┃”, position, the
engine is not started and the driver is not on
the driver's seat. If the safety belt is not
fastened properly, the safety belt alarm
indicator light will turn on.
If the safety belt is not fastened or loose when
the driver is operating the vehicle, the buzzer
alarm will sound and the safety belt alarm
indicator light will turn on at the same time.
This is to remind the driver to safely park and
refasten the safety belt; the buzzer alarm will
then stop and the safety belt alarm indicator
light will turn off.
Low brake pressure alarm indicator light
The indicator light in the 1.5t -3.5t forklift truck
is not operative.
Fault indicator light
When the forklift truck has a fault, the
corresponding fault code will be displayed.
Warning
When any fault code is displayed on the
fault indicator light, the forklift truck
should be shut down for maintenance.
To Next Page
Loading...
