HANGCHA CPCD15 - Page 34

28
1. Alarm light switch:
When pressing down, the alarm light will flash;
when pressing up, the alarm light will turn off.
2. Rear headlight switch:
When pressing down, the rear headlight will
turn on; when pressing up, the rear headlight
will turn off.
3. Engine fault detection switch (Cummins
engine only):
The indicator light is always on when there is a
fault with the engine, set the key switch in ┃
(open) position and set the engine fault
detection switch to the "Fn" or "open"
position, or the indicator light will
flash at different frequencies to indicate a
particular fault code, which can then be used
to address the fault.
4. Engine fault detection paging switch
(Cummins engine only):
If there are multiple faults, the engine fault
detection paging switch "+, -" can be used to
display the remaining faults, after all faults are
removed, , or indicator light will turn
off. Set the "Engine Test" switch to the "off"
position and the key switch to o (off) position,
and then the engine can be started after 30
seconds.
Rocker switch in a forklift truck with a cab may
be different in configuration. Add functions like
ventilation and demisting.
5. Differential lock switch
Press down to lock the differential; press up to
unlock the differential.
The differential lock is a mechanism installed
on the central differential. Its function is to
improve the traction of the forklift truck in
poor road conditions or extreme conditions,
when one wheel of the forklift truck is slipping
the differential lock can quickly lock the wheels,
so that they become rigidly coupled. In this way,
most or even all the torque can be transferred
to the wheel that is not slipping, and maximum
traction can be achieved so that the forklift can
continue moving.
Caution
 The differential lock is only to be used
under poor road conditions or extreme
conditions, and long-term use during
normal driving will cause serious
damage to the tires, drive shafts and
other components. Therefore, please
push the differential lock switch upward
when driving normally.
 The differential lock must be switched to
the power-off state.
(4WD rough terrain forklift truck)
1. Alarm light switch:
When pressing down, the alarm light will flash;
when pressing up, the alarm light will turn off.
2. Rear headlight switch:
When pressing down, the rear headlight will
turn on; when pressing up, the rear headlight
will turn off.
3. 2WD/4WD Switch
Press down to switch to 4WD mode; press up
to switch to 2WD mode.
Switch to 4WD mode to increase traction when
the front wheels are slipping.
Caution
 4WD mode should only be used in poor
road conditions or extreme conditions,
 2WD mode should be used for normal
driving.
 Please use the 2WD mode when the
forklift is turning on the highway or
gravel roads, or rainy, snowy or icy
surfaces.
4. Differential lock switch
Press down to lock the differential; press up to
unlock the differential.