Setup/Installation
13
Connect the power adapter cable to the
rear socket of the bench cradle. Verify
the battery icon indicates charging when
meter is powered.
Wall Cradle Setup
Choose suitable wall location. Use the
drilling diagram to drill holes as indicated.
(Use 2.5 mm or US #3 bit).
Fasten the wall cradle using the provided
screws. Snap cover over screw heads.
Connect the power adapter cable to the
bottom socket of the wall cradle.
Connect the probe connector to the
socket located at the bottom of edge™.
Slide edge™ into the wall cradle. Verify
the battery icon indicates charging when
meter is powered.
Setting Up
edge™
To Next Page
Loading...
