Hanna Instruments Edge User Manual

Operational Guide
43
The probe serial number together with the current
reading.
If a buer is not from the last calibration, the buer
tag will be displayed blinking.
In Standard Mode, Condition, Response gauges
are visible on the day of calibration (See Electrode
Condition And Electrode Response Time page 34). If
congured in SETUP, a countdown message displays
the number of days remaining until a new Calibration
is due.
If using a HI 11311 or HI 12301 sensor, the glass
impedance is continuously monitored, updated and
reported here and the Junction Condition Gauge is
fully visible.
When a pH electrode is connected, the instrument
will recognize it and the “REMOVE PROTECTIVE AND
FILLING CAPS” message will be displayed along
with “PH”. Press any key to skip the message. The
instrument will enter measurement mode. Make
sure the electrode has been calibrated before taking
measurements.
pH GLP
Information
pH
Measurement

Hanna Instruments Edge Specifications

General

Brand	Hanna Instruments
Model	Edge
Category	Multimeter
Language	English