Hanna Instruments Edge User Manual

Operational Guide
29
pH meter operation is congured by using the SETUP key with a pH probe
connected to the meter. The parameter-specic parameters will be seen
inserted into the menu. If Basic mode is congured “On”, the pH parameter list
will not be displayed. See Basic mode for a description of this operation before
choosing how to SETUP the meter.
Parameter Description Choices Default Basic mode
Basic Mode
When “On”, a limited set of
parameters and calibration
buers are available for
use.
O or
On
O Available
Information
Visual indication of buers
used, Probe Condition
and Response times are
determined and displayed
when calibration uses 7 and
4 and/or 10 pH buers.
O or
On
On
Buers used, probe
conditions, and
response times are
not displayed.
First Custom
Buer
When “On”, it permits the
user to enter a custom pH
buer value to use during
probe calibration.
O or
On
O Not Available
Second
Custom Buer
When “On”, permits user to
enter a custom pH buer
value to use during probe
calibration.
O or
On
O Not Available
First
Calibration
Point
Allows the user to choose
how the rst point in
calibration will be made.
Oset
or point
Oset
Not Available
(automatically uses
Oset).
Resolution
Allows the user to select
between 0.01 and 0.001 pH
resolution.
0.01 Or
0.001
pH
0.01 pH
Not Available
(automatically uses
0.01 pH resolution).
Set Out Of
Calibration
Range
When “On”, a measurement
outside the calibration
buer window used will
trigger a warning message.
O or
On
On
Not Available, No
Error messages
displayed.
pH Meter
Conguations

Hanna Instruments Edge Specifications

General

Brand	Hanna Instruments
Model	Edge
Category	Multimeter
Language	English