Installation & Controller Start-Up 20
To wall mount the controller:
1. Select the position desired for the controller and following the dimensions indicated in Figure 5, drill the
holes required for attaching the Wall‑Mount panel to the surface. The drill size depends on the fasteners
dimension required by wall type and thickness.
2.
Fasten the Wall‑Mount panel to the controller following Figure 7 schematic, and using supplied screws
and washers.
3. Fasten the mounting panel to the wall (surface), using four bolts.
4. For horizontal wall mount, use a leveling tool to adjust the controller in correct horizontal position.
4.1.3. Panel Mount
Inside Depth, Width & Height Dimensions
• 122 mm (4.80”) minimum inside depth i.e. the dimension it extends behind the panel
• 138 mm (5.4“) width x 138 mm (5.4“) height
• panel thickness can go up to 10 mm (0.39“), depending on material
11 mm
[
0.433”
]
160 mm
[
6.3”
]
38 mm
[
1.5”
]
Figure 8: Panel Mount, Inside Depth
45°
138 mm 0
+1
5.43” 0.00
+0.04
138 mm 0
+1
5.43” 0.00
+0.04
5 mm
[
0.2”
]
Figure 9: Panel Mount Cutout
To Next Page
Loading...
