45 Channel
Alarm Low (Alarm Low Enabled must be checked first)
Allows users to set the lower‑limit value for the alarm.
• To modify the value, with Alarm Low selected, press Set. The blinking of the selected value indicates that
value can be modified by using the
ud keys.
• Press CFM. Once confirmed, the value stops flashing.
• Press the
b key, to return to the menu.
Mask Time (Alarm High Enabled or Alarm Low Enabled must be checked first)
Option: 0 to 30 minutes (0‑59 seconds, 1:00 to 30:00 minutes)
Mask time is an Alarm delay timer. If alarm condition is detected, alarm will became active after "Mask time"
units of time before activating the alarm.
• Press Set, to modify the value. The flashing value indicates that it can be modified.
• Press the
ud keys followed by CFM, to save. Once confirmed, the value stops flashing.
• Press the
b key to return to the menu.
Delay Off Time (Alarm High Enabled or Alarm Low Enabled must be checked first)
Option: 5 to 999 seconds
Delay Off Time is an off delay timer. Once the alarm becomes inactive from alarm condition point of view it still
remains active for "Delay Off Time" units of time.
• Press Set to modify.
• Press the
ud keys to modify the flashing value.
• Press CFM to save. Once confirmed, the value stops flashing.
• Press the
b key to return to the menu.
Note: The controller validates the configured Setup when attempting to exit menu and directs the user to any
invalid parameters. At prompt to save changes, press YES.
To Next Page
Loading...
