Channel 44
Parameter
Option: see 2.2 Supported Probe Series Configurations for all available parameters.
With Parameter selected, press the corresponding virtual key to toggle between options.
Alarm High Enabled
Option: Enabled, Disabled
•
With Alarm High Enabled selected, press the corresponding virtual key to toggle between enable or disable
options. The check mark confirms parameter is enabled.
• Press the
b key to save.
Alarm High (Alarm High Enabled must be checked first)
Allows users to set the upper‑limit value for the alarm.
•
To modify the value, with Alarm High selected, press Set. The flashing digit indicates that value can be
modified. Press the ud keys, to modify.
• Press CFM, to save. Once confirmed, the value stops flashing.
• Press the
b key to return to the menu.
Note: A Control Setpoint value cannot be the same as the Alarm Setpoint.
Alarm Low Enabled
Option: Enabled, Disabled
•
With Alarm Low Enabled selected, press the corresponding virtual key to enable or disable. The check mark
confirms parameter enabled.
• Press the
b key, to save.
To Next Page
Loading...
