77 General Settings
Controller Password
Option: 00000 to 99999
• With item selected, press Modify for the password input screen.
• Press the
u key to increment the digit (displayed flashing) and the d key to decrement.
• Press CFM, to save.
• Press the
r key to navigate right between digits.
Controller password protects against unauthorized changes. It is required if modifications are made.
After the password has been enabled, parameter modifications or probe calibration data are password protected.
• Entering the password unlocks the controller
-->
ё.
• In measurement mode, the controller is automatically locked again after about 10 seconds
-->
е.
For further details, see Enabling & Disabling the Password section.
Enabling & Disabling the Password
To enable the password:
1. From Main Menu, press the
u or d key to navigate to General setup, Controller password.
2. With Controller Password menu item selected, press Modify.
3. Use the ud keys to modify the flashing digit, press the r to move places, repeat.
Then press CFM, to confirm the choice.
4. Rekey the password and press CFM to save the password.
To Next Page
Loading...
