General Settings 78
5. Once the password has been enabled, the controller displays the confirmation screen and a check mark
will appear.
Note: After the password has been enabled, Setup changes are password protected.
Entering the password unlocks the controller
-->
ё.
In measure mode, the controller is automatically locked again after about 10 seconds
-->
е.
To disable the password:
1. Press Modify and use the
ud keys to enter the password.
2. Ignore prompt to enter new password and press Disable. The password is automatically disabled.
Note: If the password is entered incorrectly five times, users will require assistance from Hanna Instruments
service team.
Controller ID
Option: 0000 to 9999
• With Controller ID selected, press Set to modify.
• Press the
ud keys to increase or decrease the value (keep the key pressed to fast‑forward).
• Press CFM, to save.
Note: If you have more than one Controller it is advisable to give each a separate Controller ID.
Remote Control
Option: Enabled, Disabled
This option allows the user to enable Remote Control. This must be enabled if using the Modbus protocol.
With item selected, press the corresponding virtual key, to toggle between options. The check mark confirms
the enabled parameter.
To Next Page
Loading...
