Instructions for operation
General instructions for operation
Caution: If the instructions are not obeyed during operation, this causes
damage to the gear unit.
Procedure
1. Give all the instructions in this chapter to the owner of the gear unit.
These instructions are a part of the instructions of a larger system in which the gear
unit is one part.
Instructions (force-feed lubrication, pump with a motor)
Procedure
1. Make sure that a pump goes on minimum 60 s before the gear unit starts.
Instructions (water cooling)
Procedure
1. Drain the cooling water if the gear unit does not operate and the ambient
temperature is below the freezing point.
Instructions (drive group with a 2-speed motor)
Procedure
1. Before you change from the higher to the lower speed, decrease the speed below
the lower speed.
Then, the motor must increase the speed to the lower speed. This condition prevents
that the torque to the gear unit becomes too high.
Instructions if the gear unit does not operate more than 2 weeks
Procedure
1. Do one of these procedures:
• Operate the gear unit for minimum 5 minutes each 2 weeks.
• Protect the gear unit with a volatile corrosion inhibitor.
2. Before you start again, do all instructions in chapter
Commissioning
on page 44.
10
10.1
10.2
10.3
10.4
10.5
Instructions for operation
46
IM_405_002_EN
To Next Page
Loading...
Need help?
General
