-CS -24
BOBBIN WINDING
Winding the bobbin
4_4 K101
4-4
Thread the bobbin winder as shown below:
1. Upper Thread guide
2. Thread guide
3. Thread tension – Be sure to thread through the
small eye before going between the disks.
4. Bobbin (Place the bobbin on the bobbin winder
spindle.)
5. Press the limit lever as indicated by the arrow
to start the winder. The lever stops the winder
automatically after the winding is complete.
1
2
3
4
5
Increase Decrease
Tension
When adjusting bobbin winder tension:
• Ensure thread winds evenly on bobbin as
shown.
Confirm that the bobbin is wound properly..
• Keep the tension constant while winding.
Tighten thread tension if thread winds too loosely.
CAUTION: To prevent accidents.
When lever is pressed down, the bobbin
winder spindle and the bobbin start turning.
Keep fingers and body away until the bobbin
winder stops turning.
To Next Page
Loading...
