Happy HCS - SEWING; What to do if the thread breaks while sewing; Stopping and resuming sewing

-CS -59
START STOP
+
-
START STOP
+
-
START STOP
+
-
9-1
SEWING
9_1 D610
What to do if the thread breaks while sewing
In case thread breaks and thread shorts while sewing. The machine senses a thread break and
the frame moves back several stitches from the broken point and the machine stops.
(This function is to prevent open sections in the design when you start sewing again. See
Thread break back.
5-2)
If the upper thread breaks
Thread upper thread again.
(Reference to thread upper thread
4-6)
In case bobbin thread breaks
Thread lower thread again.
(See preparation of bobbin winding.
4-5)
CAUTION: To prevent accidents.
When performing a thread trim, be careful of
the needle which will enter the fabric.
CAUTION: To prevent accidents.
When turning power on, the embroidery
frame will make a sudden move to the front
and right side. Please keep your hands and
body from contacting the machine.
As an example; An unsatisfactory gap between
blocks and block. Because stopped machine at half
point of embroidery and shrunk material.
Stopping and resuming sewing
If you wish to turn off the machine power while
sewing, you may re-start sewing from the
suspended point after turning on the machine
power again and then re-starting.
You need carefulness that suspending ma-
chine with sewing of pattern data half done
left and when some time pass and re-start
sewing, cloth crease may occurs, there
might be gap between sewing part which
you add after stopping machine and re-start
sewing and it's cloth crease by sewing.
To suspend sewing
1. Stop the sewing by pressing the "STOP"
button.
2. Press the "Thread trim" button.
3. Turn off the power switch.
To start embroider again from half point of design
4. Turn on the power switch.
5. Press the "ENT." button.
The carriage and frame will move to the front
side and the right automatically and then will
return to the original point.
6. Back up several stitches from the stopped
point by pressing the stop button 3-4 times.
7. Start sewing again by pressing the "START"
button.
ON
OFF
P.FOOT T.CUT
MENU
FORWARD
ENT.
2
ON
OFF
1
3
4
5
6
P.FOOT T.CUT
MENU
FORWARD
ENT.
7