Hardy Instruments A Series - Configuration Parameters for the HI 1765-WS Module

HI 1756-WS WEIGH SCALE MODULE
4-4
Configuration
Parameters for the HI
1765-WS Module
With version 2.3 software, the HI 1765-WS module
can recieve 32 words of the configuration data from a
PLC upon power-up. These data are used only if the
value for Config_rev_num is set to 1 and the parame
-
ters are sent in the correct format and range.
NOTE: DINT Parameters can be interpreted as floating point
based on the value of a bit within the DecimalPoints
parameter of the channel.
Parameter
Offset (In
Words)
Single Channel
Config_rev_num0 *
0
ChanEnabled0
1
DecimalPoints0 **
2
Metric0
3
NumAverages0
4
Waversaver0
5
SpanWeight0
6
CalLowWeight0
7
ZeroTrackEnables0
8
AutoZeroTolerance0
9
MotionTolerance0
10
TareWeight0
11
EnableButton0
12
RocTimeBased0
13
ZeroTolerance0
14
Spare1_0
15