Hardy Instruments A Series - Setting the Span Weight Value; Setting the WAVERSAVER Value

To Next Page

To Previous Page

Chapter 4 - Setup

4-23

Setting the Span

Weight Value

The Span Weight is a reference point derived from an

actual measured weight. This should not be confused

with the Scale Capacity. If you have a 100 pound

weight and you place it on the scale, the Span Weight

would be 100 pounds.

Setting the

WAVERSAVER

Value

There are 5 selectable levels. 0 provides the least

vibration immunity with the fastest response time. 4

provides the most vibration immunity with the slow

est response time. Default setting is 2.

Immunity Setting

7.5 Hz 0

3.5 Hz 1

1.0 Hz 2

0.5 Hz 3

0.25 Hz 4