Hardy Instruments A Series - Write Non-Volatile Command (WRITENONVOLATILE); Reload Non-Volatile (RELOADNONVOLATILE); Enable Calibration Button Command (ENABLEBUTTONCMD)- -4-13; Set Default Parameters (SETDEFAULTPARAMS)

Chapter 4 - Setup
4-13
Write Non-Volatile
Command
(WRITENONVOL
ATILE)
The Write Non-Volatile Command causes all parame-
ters (including calibration constants) to be saved to
the non-volatile memory.
Command Number: 4 (Hexadecimal)
Channel Number: 0 or 1
Number of Elements: 8
Error Return Values: None
Reload Non-
Volatile
(RELOADNONVOL
ATILE)
The Reload Non-Volatile Command causes the weigh
module to re-read the values stored in its non-volatile
memory. Any parameters changed since the last write
non-volatile command are overwritten. this command
can be used to abort a calibration or parameter entry
session.
Command Number: 0x10 (Hexadecimal)
Channel Number: 0 or 1
Number of Elements: 8
Error Return Values: None
Enable Calibration
Button Command
(ENABLEBUTTON
CMD)
The Enable Calibration Button Command activates
the calibration button.
Command Number: 20 (Hexadecimal)
Channel Number: 0 or 1
Number of Elements: 8
Error Return Values: None
Disable
Calibration Button
Command
(DISABLEBUTTON
CMD)
The Disable Calibration Button Command deactivates
the calibration button.
Command Number: 40 (Hexadecimal)
Channel Number: 0 or 1
Number of Elements: 8
Error Return Values: None
Set Default
Parameters
(SETDEFAULTPAR
AMS)
Load the default settings into RAM, and non-volatile
RAM.
Command Number: 0x94 (Hexadecimal)