Hardy Instruments A Series User Manual

Chapter 1 - Overview
1-1
CHAPTER 1 - OVERVIEW
A BRIEF
DESCRIPTION OF
CHAPTER 1
This manual is designed for use by installers, opera-
tors, and service personnel. It provides specifications
and procedures for linking, configuring, operating,
maintaining, and troubleshooting the Hardy Instru
-
ments HI 1756-WS and HI 1756-2WS ControlLogix
®
I/O Weigh Scale Modules.
NOTE: Control/Logix
®
is a registered trademark of the Rock-
well Corporation.
Both modules come with WAVERSAVER
®
, C2
®
but-
ton-triggered calibration, INTEGRATED TECHNICIAN
(IT
®
) diagnostics, and ladder logic configurability.
NOTE: WAVERSAVER
®
, C2
®
, INTEGRATED TECHNICIAN
®
are
registered trademarks of Hardy Instruments Inc.
Before using the product, be sure you understand all
cautions, warnings, and safety procedures stated or
referenced in this manual. And, to get the best service
from this product, follow the practices recommended
in this manual.
Hardy Instruments appreciates your business. We
welcome all corrections or suggestions for improve
-
ment of this manual. Should you not understand any
information in this manual or experience any prob
-
lems with the product, please contact our Customer
Support Department at:
Phone: (858) 278-2900
FAX: (858) 278-6700
e-mail: support@hardyinst.com
Web: hardyinst.com
About This Manual Chapter 1 - Introduces the instruments and provides
an overview of the their capabilities
Chapter 2 - Provides a list of specifications
Chapter 3 - Contains instructions needed to install
the HI 1756-WS and HI 1756-2WS (both standard
and optional equipment) and the Remote Termination
Assembly (-RTA)

Hardy Instruments A Series Specifications

General

Brand	Hardy Instruments
Model	A Series
Category	Control Unit
Language	English